From an external viewpoint of view, RTA and Sub-Ohm tank looks very similar and difficult to distinguish. However, the biggest difference in their interior, and a substantial difference between the two stand out. Sub-Ohm tank is easy to identify because the coil is replaced and mounting make it clear. On the other hand, RTA build platform may be complex, so that beginners can not be confused with intricate designs and layouts. They all have their own advantages and disadvantages, and it is up to the e-cigarette atomizer to decide which to use. Let’s look at the RTA and Sub-Ohm tank and see which one is best for your vaping service.
RTA superior when looking for a delicious flavor. I would not underestimate the tin sub-ohm and their ability to produce aroma, but in general, the output sense RTA will exceed many sub-ohm cans. With the ability to accommodate a crooked manual reels, the RTA can adapt to ambitious coil structures that would never appear in a pre-built replacement reels, so the clouds extreme or flavors, which can be customized according to user preferences. RTA has a construction platform that can accept single-coil or dual-coil configuration and a special air flow path that really impact one or more coils to pull evaporate eJuice to the tongue and lungs. On the other hand, the central air flow of prefabricated coil used in Sub-Ohm tank vertical passing through the coil, so most flavor absorbed than half of the coil is exposed, while the other half kept in contact with a cotton wick suction medium. In addition to,smok vape
Both RTA and Sub-Ohm storage tank has a large capacity, especially when the glass bubbles are introduced. Depending on the selected storage tank or RTA, the maximum capacity could reach more than 4ml. This will reduce the amount of filling the tank May issue sub-ohm or the RTA before introducing tank glass bubble. The important difference between the two is that most of the fuel tank sub-ohm have a control system airflow is placed into the bottom of the tank, because the system wicking depends on the pieces that are blocked by parts of cotton wicking, which leads to the center Coil, which blocks most of the electric potential , leakage. However, RTA tends to keep the air flow control system above to prevent this type of potential leakage problem because the RTA must be evil by hand, which allows users to use more or less cotton to slow down or speed up the rate of wicking.
RTA is usually more expensive than the tank Sub-Ohm, but this usually applies to the initial cost of the tank atomizers rebuildable and coil building materials. In the case of the RTA, because the coil wound manually, they can be made into a coil of cable at a fraction of the cost of replacement coils, so that the number of coils that are provided over a replacement package can provide. However, the money saved would be a waste of time. It takes a lot of time and effort to replace the coils on RTA. In this case, the Sub-Ohm tank will win because the tank has a variable coil, and users can only pull or loosen the coils used and replace it with a new coil in less than one minute. After the RTA decided that the coils can be replaced, he must take the time to remove the old coil and build and install a new coil. This process can easily take 10 minutes or more.