Why you vape Burnt Tastes and How to Fix

What causes burns?
When there is no liquid in the core trunk or sufficient liquid core, supplying power to the atomizer can cause burns. Without evaporation of the liquid, the coil began to burn the wick, and the user basically cotton breathe fire. Here are some of the most common causes of burns, and some suggestions to help you avoid this problem.Pallas Mechanic Resin

high wattage
Evaporation of the coil wattage exceeds the limit e-liquid will evaporate too quickly. When this happens, the coil can burn the wick even if no juice there. Always stay within the recommended power range.

Quick Links:intake rta,RPM80 Pro,Q-ULTRA Pod

chain suck
When inhaling continuously, the axis will dry quickly. If you notice the smell of roasting a little and feel the smell of caramel to come, please enter while down vape it. This would allow the liquid to cover the dry point axis.

Use high VG E-Liquid
Atomization atomization Not all are the same. Some vape storage tanks can withstand high VG juice, while the other storage tanks usually require 50% PG or PG higher to function properly. A good rule is to check the size of the channel axis. If the hole diameter is small, the water tank you might not be able to adapt to high VG juice.

Coils are not oiled properly
This is probably the most common problems on the list. Flush head coil is basically an immersion process with e-liquid axis so that they are ready for first use. If you want to avoid burns, remember to always instill the correct coil.Augvape vape

Install coil: stop burning
Although the idea is always the same, coils priming process varies depending on the equipment used. This is some of the most common methods used infusion vape.LOST VAPE

How prime vape tank coil
All tanks vape with replaceable head coil has more or less the same structure and requires simple steps are the same for priming. This process must be repeated each time the coil is replaced.

Quick Links:SCAR-18 Kit,SMOK SCAR-P3,Scar P5 kit

Coils new out of the box
Drop some e-liquid wicking into the hole and the head coil (3-4 drops enough)
Assemble the water tank and pour the juice
Screw up your tank at the Department of Defense and set aside for 10 minutes
Inhalation at the top of the fuel tank without ignition will speed up the process
For mods vape with adjustment function watt, please start with the lowest recommended wattage and gradually increase until you find the best position
Please note that as more fluid can accumulate inside the coil, you may experience some spit during the first suction. If it does not disappear, and you use a variable watt modulus, try to increase the strength of a couple of times, but make sure you do not exceed the limit watt coil, because it is possible to burn it.